Features

• • Fill w/ High Alarm
  • 2-Contact point system
  • 6-wire Dry contacts to BAS for measuring Fill “ON” time
  • High Water Alarm and Fault conditions
  • Operates any 110VAC valve & 110VAC audible alarm (Not supplied in this kit – see options section).

Usage

We see this control used mostly as a high and low alarm and not as a fill switch, using the Fill switch as the low alarm and the High alarm as the high alarm. The application does not matter. The fill switch in this controller turns on at one probe and off at another.

To use it as an alarm instead of a fill device, inside the control panel the installer just puts the two sensors together so the switch turns on and off at the same set points for the low alarm. The high alarm works on one probe only so it would just be put in at the correct height for the high alarm.

Description

There are three outputs which:

1. 1. Close a set of dry contacts for a BMS
   2. Operate a relay rated at 30AMPS for 250VAC
   3. Turn on an LED to indicate this sensor has tripped.

The Control Panel has visual displays indicating power to the level control panel, when the control panel is actively filling and the high water alarm. The Fill dry contacts can be used as a comparative to develop a baseline benchmark of water usage for the system.