NEVER REPLACE
An Electronic Water Controller Again!

Call Waterline Controls
1(888) 905-1892

WLC-7000 Pump Down System

Complete Kit Includes:

  • Sensor With 50 ft. Sensor Wire*
  • Controller

Features

The system is comprised of a sensor and sensor housing with wire attached and installed at water level operating range, control panel mounted at a convenient location and a relay to operate a pump or gate valve.

Usage

This is a single pump down system for use in places where all you need to do is make sure the environment stays clear of water. The relays in the panel are intended to be used as pilot relays for larger contactors operating large pumps to remove water from a sump.

Description

Control Panel displays:

  1. Power
  2. Pumping
  3. Fault indicator
  4. Test system to test the electronics portion of the controls without removing or disconnecting the probes

There is a time delay between sensing and pumping before initializing the relay to operate a pump or gate valve. It has a switch to activate the test process and it will automatically cycle through the pump process. The system has a light to indicate that it is in the test mode. The “Fault” indicator will change the power LED (green) to red when the “Pump” command has been “ON” for greater than six continuous hours. After one minute it will turn back to green and the system will function normally.

*Custom Sensors lengths available upon request.

If you are a Reseller, Sales Organization, Distributor, Contractor or an OEM we want to talk with you to determine an SPA price program for your organization so please call us at 1(888) 905-1892 or contact us now.